null

Rear Polyurethane Coil Spacer - 30mm Suited For Toyota 80 / 100 Series Land Cruiser/ Lexus LX450 / LX470

Part Number: LCR30
$40.00
In Stock
Current Stock: 193
Shipping:
Calculated at Checkout
Make:
Toyota
Model:
80 Series Land Cruiser
Model:
100 Series Land Cruiser
Make:
Lexus
Model:
LX450
Model:
LX470
Year:
1990
Year:
1991
Year:
1992
Year:
1993
Year:
1994
Year:
1995
Year:
1996
Year:
1997
Year:
1998
Year:
1999
Year:
2000
Year:
2001
Year:
2002
Year:
2003
Year:
2004
Year:
2005
Year:
2006
Year:
2007
Make:
AM General / Hummer
Model:
HMMWV / H1
Year:
1986
Year:
1987
Year:
1988
Year:
1989
Gift-wrapped Truck
Free shipping on orders over $99 to the lower 48 states

Rear Polyurethane Coil Spacer - 30mm Suited For Toyota 80 / 100 Series Land Cruiser/ Lexus LX450 / LX470

Produced from high density injection moulded polyurethane, allow fine tuning or larger adjustment of vehicle ride height, most commonly used to trim level after heavy accessories have been fitted.

HMMWV Video Run Down

HMMWV / HUMMER H1: These poly spacers can be installed at all four corners giving you approx 2.5" of additional lift. We recommend using "zip-ties" all around the spacer to secure it to the top of the coil. The spacer is an "interference fit" so getting the spacer to pilot into the top of the coil will not be easy. Once secured with "zip-ties" you can work around the outside of the shoulder and pry it further down into the bore of the coil. Then carefully insert the coil with the spacer still secured, back into the perch. Using a floor jack, lift from underneath the lower control arm and carefully seat the spacer into the top spring perch. As you continue to apply slow pressure with the jack, the lower shoulder of the spacer will fully seat into the bore of the coil. Once installed, cut and pull away the "zip-ties" with locking pliers. "Zip-tie" removal is made easier if you install them down in the relief grooves on the top face of the poly spacer. Once you're done and everything is bolted back together, take a paint pen and mark all your bolts and the position of the poly spacer for reference. If somehow something gets loose, you can tell by the paint marks you made during install. 

Usually when you add pre-load to a coil you get a harsher ride. HOWEVER! I couldn't believe how much better the ride in my M998 was after installing these. The polyurethane spacers are a heck of a lot squishier than steel spacers and now all those highway road vibrations are gone. We can all thank MILLER for pointing out that the springs on my M998 looked to be about the same size as an 80 series Land Cruiser spring... Well, after lots of arguing in my garage turns out MILLER was right! And I was wrong...

"He's losing his mind! And I'm reaping all the benefits..." - Jimmie Moore the Wedding Singer 

  • 30mm height or 1.18"
  • Package Details: Sold individually

WARRANTY

 
warranty-3-year-02.png
Store Finder

Locate a brand store, partner store or retail partner in your area.

Be the First to Know

Sign up for special promotions and new product releases

Customer Support Center

Need more information? Have a repair concern? No problem. We're here to help.

Close